Lantronix
Idle timeout
The messages: "Warning: Idle timeout. The session will be closed." and "Login timed out after 60 seconds."
display after 60 seconds of CLI inactivity. Hit the Enter key, wait for the login prompt to display, then log back in
to the SESPM1040-541-LT.
#
Warning: Idle timeout. The session will be closed.
Debian GNU/Linux 9
SESPM1040-541-LT login:
Note: If the CLI login time is extensive (20 seconds) try disabling the TACACS+ and Radius servers.
CLI Command Controls
The switch provides these commands for CLI control:
?
Display the set of commands supported in the current CLI command mode.
<cr>
Executes the command; same as <Enter>.
<tab>
Displays the available commands in a mode in tabular format.
<Backtab>
Erases cli command one character at a time.
↑
Go to the previous command entry.
↓
Go to the next command entry.
CLI Command Modes
The switch supports these CLI command modes: Exec Mode, Config Mode, and Interface Config Mode.
Mode
Exec Mode
Config Mode
Interface Config Mode
The following sections describe the CLI commands in each mode.
33773 Rev. F
Description
The initial (startup) CLI mode.
Enter from Exec mode with the
command.
configure terminal
Enter from Config mode with the
interface GigabitEthernet
command.
interface vlan
https://www.lantronix.com/
SESPM1040-541-LT-xx Operation Guide
SESPM1040#
SESPM1040(config)#
SESPM1040(config-if-1/2)#
or
or
SESPM1040(config-if-vlan-1)#
Prompt
Page 18 of 228