Table of Contents
Advertisement
❒ 3 x 3, 4 x 4 and 5 x 5 refer to areas
(in dots) searched when elimi-
nating dots and marks. Isolated
marks that fit into the frame
(width: 1 dot) of the specified
area are searched and erased.
For example, if 5 x 5 is specified,
isolated dots with a maximum
size of 3 x 3 are erased.
❖ ❖ ❖ ❖ Edge Smoothing
This smoothes the edges of charac-
ters, illustrations and so forth, dur-
ing the scanning process.
The factory default is "Off".
Note
❒ This setting is available except
when the scan type is "Color".
❖ ❖ ❖ ❖ Filter
It is possible to specify whether
you want to filter scans or not. You
c a n s e l e c t f r o m " O f f " , " F i n e
Noise(2x2) ", and "MTF".
• If you select "Off", the scan is
not filtered.
• If you select "Fine Noise(2x2)",
the scan is shaded.
• If you select "MTF", the scan is
sharpened.
The factory default is "Off".
❖ ❖ ❖ ❖ Positive/NegativePositive/Negative
You can reverse the polarity of
your scans from positive to nega-
tive. You can select from "On" and
"Off".
The factory default is "Off".
Note
❒ This setting is available except
when the scan type is "Full Col-
or".
Registration Operation
Sequence
Preparation
Before you can register scan condi-
tions, you must first make initial
settings so that the scanner can be
used as a network delivery scan-
ner. ⇒ P.15 "Use as a Network Deliv-
ery Scanner"
A
Press the { { { { User tools} } } } key.
The Scanner Features screen ap-
pears.
B
Press [Scan].
C
Use the number keys to enter the
number of the name for which
you want to register scan condi-
tions.
Scan type is displayed as the first
item of scan conditions.
Scan Setup
2
ZDLH470
19
Advertisement
Table of Contents
