Trane TR200 Operating Instructions Manual page 28

8-05 End-of-Timeout Function
[0] Hold set-up
[1] * Resume set-up
8-06 Reset Control Timeout
[0] * Do not reset
[1] Do reset
8-07 Diagnosis Trigger
[0] * Disable
[1] Trigger on alarms
[2] Trigger alarm/warn.
8-09 Communication Charset
[0] * ISO 8859-1
[1] ANSI X3.4
8-30 Protocol
Option:
[5] BACnet
8-31 Address
Range:
1. * [1. - 127. ]
TR200 Embedded BACnet Operating Instructions
Option:
Function:
Select the action after receiving a valid control word following a time-out. This
parameter is active only when par. 8-04
up 1-4].
Retains the set-up selected in par. 8-04
warning, until par. 8-06
converter resumes its original set-up.
Resumes the set-up active prior to the time-out.
Option:
Function:
This parameter is active only when the choice Hold set-up [0] has been selected
in par. 8-05 End-of-Timeout Function
Retains the set-up specified in par. 8-04
setup 1-4] following a control time-out.
Returns the frequency converter to the original set-up following a control word
time-out. When the value is set to Do reset [1], the frequency converter performs
the reset and then immediately reverts to the Do not reset [0] setting.
Option:
Function:
This parameter has no function for BACnet.
Option:
Function:
Function:
Communication according to the BACnet protocol as described in TR200
Embedded BACnet Operating Instructions.
Function:
Control Timeout Function
Control Timeout Function
Reset Control Timeout toggles. Then the frequency
.
Control Timeout
Parameters
is set to [Set-
and displays a
Function, [Select
27