Ricoh 480W Network Manual page 61

Parameter Value configured
key [ "key value" ] You can specify
val [1|2|3|4] the WEP key when
entering in hexa-
decimal.
With a 64-bit WEP,
you can use 10 digit
hexadecimals. With
a 128-bit WEP, you
can use 26 digit hex-
adecimals.
Up to four WEP
keys can be regis-
tered. Specify the
number to be reg-
istered with "val".
When a WEP is
specified by key,
the WEP specified
by key phrase is
overwritten.
To use this func-
tion, set the same
key number and
WEP key for all
ports that transmit
data to each other.
You can omit the
numbers with
"val". The key
number is set to 1
when making
these omissions.
keyphrase [ You can specify
"phrase" ] val the WEP key when
[1|2|3|4] entering in ASCII.
With a 64-bit WEP,
you can use 10 digit
hexadecimals. With
a 128-bit WEP, you
can use 26 digit hex-
adecimals.
Up to four WEP
keys can be regis-
tered. Specify the
number to be reg-
istered with "val".
When a WEP is
specified by key
phrase, the WEP
specified by key is
overwritten.
Remote Maintenance by telnet
Parameter Value configured
keyphrase [ To use this func-
"phrase" ] val tion, set the same
[1|2|3|4] key number and
WEP key for all
ports that transmit
data to each other.
You can omit the
numbers with
"val". The key
number is set to 1
when making
these omissions.
encval [1|2|3|4] You can specify
which of the four
WEP keys is used
for packet encod-
ing. "1" is set if a
number is not
specified.
auth You can set an au-
[open|shared] thorization mode
when using WEP.
The specified val-
ue and authorized
mode are as fol-
lows:
open: open system
authorized (de-
fault)
shared: shared key
authorized rate
rate [au- You can set the
to|11m|5.5m|2m IEEE 802.11b trans-
|1m] mitting speed.
The speed you
specify here is the
speed at which
data is sent. You
can receive data at
any speed.
auto: automatical-
ly set (default)
11m: 11 Mbps
fixed
5.5m: 5.5 Mbps
fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
3
57