Route; Set - Ricoh 480W Network Manual

❖ ❖ ❖ ❖ Changing the Password
msh> passwd
• Enter the current password.
• Enter the new password.
• Enter the new password once
again.
Note
❒ Be sure not to forget or lose the
password.
❒ The password can be entered using
up to 32 alphanumeric characters.
Passwords are case-sensitive. For
example, "R" is not the same as "r".

route

Use the "route" command to control
the routing table.
❖ ❖ ❖ ❖ All route information display
msh> route
❖ ❖ ❖ ❖ Specified route information display
msh> route "destination"
• Specify the IP address to desti-
nation.
❖ ❖ ❖ ❖ Enabling/disabling Specified Destina-
tion
msh> route active {host|net}
"destination" {on | off}
• You can turn the specified desti-
nation on or off. Host becomes
the default setting.
❖ ❖ ❖ ❖ Adding Routing Table
msh> route add {host|net}
"destination" "gateway"
• Adds a host or network route to
"destination", and a gateway ad-
dress to "gateway" in the table.
• Specify the IP address to desti-
nation and gateway.
• Host becomes the default setting.
Remote Maintenance by telnet
❖ ❖ ❖ ❖ Setting Default Gateway
msh> route add default
"gateway"
❖ ❖ ❖ ❖ Deleting Specified destination from
Routing Table
msh> route delete {host|
net} "destination"
• Host becomes the default set-
ting.
• IP address of destination can be
specified.
❖ ❖ ❖ ❖ Route Flush
msh> route flush
Note
❒ The maximum number of routing
tables is 16.
❒ Set a gateway address when com-
municating with devices on an ex-
ternal network.
❒ The same gateway address is shared
by all interfaces.

set

Use the "set" command to set the pro-
tocol information display "active" or
"inactive".
❖ ❖ ❖ ❖ View settings
The following command displays
protocol information (active/inac-
tive).
msh> set tcpip
msh> set smb
msh> set ip1394
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
msh> set protocol
• When protocol is specified, in-
formation about TCP/IP, and
smb appears.
3
51