Ifconfig; Passwd - Ricoh 480W Network Manual

Monitoring and Configuring the Machine
❖ ❖ ❖ ❖ Initializing the machine name for
each interface
m s h > h o s t n a m e " i n t e r -
face_name" clear name

ifconfig

Use the "ifconfig" command to con-
figure TCP/IP (IP address, subnet
mask, broadcast address, default
3
gateway address) for the machine.
❖ ❖ ❖ ❖ View settings
msh> ifconfig
❖ ❖ ❖ ❖ Configuration
msh> ifconfig "interface_
name" "parameter" "address"
• If you did not enter an interface
name, it is automatically set to
the Ethernet interface.
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
Interface name
ether
ip1394
wlan
❖ ❖ ❖ ❖ Netmask configuration
msh> ifconfig "interface
_name" netmask "address"
❖ ❖ ❖ ❖ Broadcast address configuration
msh> ifconfig "interface_
name" broadcast "address"
❖ ❖ ❖ ❖ Changing the Interface
msh> ifconfig "interface"
up
50
Interface configured
Ethernet Interface
IEEE 1394 Interface
IEEE 802.11b Interface
• You can specify either the Eth-
ernet interface or IEEE 802.11b
interface when using the op-
tional IEEE 802.11b interface
unit.
You cannot specify the IEEE
1394 interface.
The following explains how to
configure an IP address 192.168.15.
16 on Ethernet interface.
msh> ifconfig ether 192.
168.15.16
The following explains how to
configure a subnet mask 255.255.
255.0 on Ethernet interface.
msh> ifconfig ether net-
mask 255.255.255.0
Note
❒ To get the above addresses, contact
your network administrator.
❒ Use the default configuration if you
cannot obtain setting addresses.
❒ The IP address, subnet mask and
broadcast address are the same as
that for the ethernet interface and
IEEE 802.11b interface.
❒ When installing the optional 1394
Interface board, set the IP address
and subnet mask so that it does not
overlap with the ethernet interface
or the IEEE 1394 interface.
❒ TCP/IP configuration is the same
for both Ethernet and IEEE 802.11b
interface. If interfaces are changed,
the new interface inherits the con-
figuration.
❒ Use "0x" as the initial two letters of
a hexadecimal address.

passwd

Use the "passwd" command to
change the remote maintenance pass-
word.