Snmp - Ricoh 480W Network Manual

❖ ❖ ❖ ❖ Deleting Comment
msh> smb clear comment
❖ ❖ ❖ ❖ Protocol settings
msh> smb protocol [netbeui
{up | down} | tcpip {up |
down}]
• Enable or disable NetBEUI and
TCP/IP. Specify "up" to enable,
and "down" to disable.

snmp

Use the "snmp" command to display
and edit SNMP configuration settings
such as the community name.
❖ ❖ ❖ ❖ View settings
msh> snmp
• Default access settings 1 is as
follows:
Community name:public
IP address:0.0.0.0
Access type:read-only / trap off
• Default access settings 2 is as
follows:
Community name:admin
IP address:0.0.0.0
Access type:read-write / trap off
• If "-p" is added, you can view
settings one by one.
• To display the current commu-
nity, specify its registration
number.
❖ ❖ ❖ ❖ Display
msh> snmp ?
❖ ❖ ❖ ❖ Community name configuration
msh> snmp "number" name
"community_name"
• You can configure ten SNMP
access settings numbered 1-10.
• The community name can be
entered using up to 15 charac-
ters.
Remote Maintenance by telnet
❖ ❖ ❖ ❖ Deleting community name
msh> snmp "number" clear
name
❖ ❖ ❖ ❖ Access type configuration
msh> snmp "number" type
"access_type"
Access type Type of access per-
mission
no not accessible
read read only
write read and write
trap user is notified of trap
messages
❖ ❖ ❖ ❖ Protocol configuration
msh> snmp {ip | ipx} {on |
off}
• Use the following command to
set protocols "active" or "inac-
tive": If you set a protocol "inac-
tive", all access settings for that
protocol are disabled.
• Specify "ip" for TCP/IP, or "ipx"
for IPX/SPX.
• {on} means "active" and {off}
means "inactive".
• IEEE 1394 interface is available
for TCP/IP only.
❖ ❖ ❖ ❖ Configuration of protocol for each
registration number
msh> snmp "number" active
{ip | ipx} {on | off}
• To change the protocol of access
settings, use the following com-
mand. However, if you have
disabled a protocol with the
above command, activating it
here has no effect.
3
53