Ricoh 480W Network Manual page 28

Connecting and Setting Up
If [On] is selected, enter the
[V V V V WINS Server] IP address as
"xxx.xxx.xxx.xxx"("x" indi-
cates a number).
If DHCP is in use, specify the
[Scope ID].
• Primary WINS Server
• Secondary WINS Server
2
• Scope ID
• Off
Limitation
❒ Enter a [Scope ID] using up to 31
alphanumeric characters.
Note
❒ Default: Off
❖ ❖ ❖ ❖ Effective Protocol
Select the protocol to use in the
network.
• TCP/IP:Effective/Invalid
• SMB:Effective/Invalid
Note
❒ Default: TCP/IP: Effective, SMB:
Invalid
❖ ❖ ❖ ❖ SMB Computer Name
Specify the SMB computer name.
❖ ❖ ❖ ❖ SMB Work Group
Specify the SMB work group.
❖ ❖ ❖ ❖ Ethernet Speed
Set the access speed for networks.
Select a speed that matches your
network environment. [Auto Select]
should usually be selected.
• Auto Select
• 100Mbps Full Duplex
• 100Mbps Half Duplex
• 10Mbps Full Duplex
• 10Mbps Half Duplex
Note
❒ Default: Auto Select
24
❖ ❖ ❖ ❖ LAN Type
When you have installed the op-
tional IEEE 802.11b interface unit,
select interface, IEEE 802.11b
(wireless LAN) or Ethernet.
• Ethernet
• IEEE 802.11b
Note
❒ Default: Ethernet
❒ Appears when the optional IEEE
802.11b interface unit is installed.
❒ If Ethernet and IEEE 802.11b
(wireless LAN) are both connect-
ed to the machine, the selected
interface takes precedence.
❖ ❖ ❖ ❖ Ping Command
Check the network connection
with ping command using given
IP address.
Note
❒ If you fail to connect to the net-
work, check the following, and
then retry the ping command.
• Check TCP/IP of the machine
is active.
• Check that the machine with
assigned IP address is con-
nected to the network.
• There is a possibility that
same IP address is used for
the specified equipment .
❖ ❖ ❖ ❖ Permit SNMP V3 Communication
Set the encrypted communication
of SNMP v3.
• Encryption Only
• Encryption / Clear Text
Note
❒ If you set to [Encryption Only],
you need to set password for
the machine.