Autonet; Devicename - Ricoh 480W Network Manual

Monitoring and Configuring the Machine
Note
❒ The access range restricts comput-
ers from use of the machine by IP
address. If you do not need to re-
strict printing, make the setting
"0.0.0.0".
❒ Valid ranges must be from lower
(start address) to higher (end ad-
dress).
❒ Up to five access ranges can be
3
specified. The entry is invalid if the
target number is omitted.
❒ You cannot access Web Image Mon-
itor from a restricted IP address.

autonet

Use the "autonet" command to con-
figure AutoNet parameters.
❖ ❖ ❖ ❖ View settings
The following command displays
the current AutoNet settings:
msh> autonet
❖ ❖ ❖ ❖ Configuration
You can configure AutoNet set-
tings.
msh> autonet {on|off}
• {on} means "active" and {off}
means "inactive".
❖ ❖ ❖ ❖ Current interface priority configura-
tion display
msh> autonet priority
❖ ❖ ❖ ❖ Interface priority configuration
m s h > a u t o n e t p r i o r i t y
"interface_name"
• You can give interface's Au-
toNet parameter priority.
• Priority settings are available
when multiple interfaces are in-
stalled.
46
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only when
the IEEE 802.11b interface is in-
stalled.
Interface name Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b interface
Note
❒ If an interface is not selected, the
current interface connection set-
tings remain in effect.
Reference
For details about AutoNet, refer to
autonet parameters.

devicename

Use the "devicename" command to
display and change the machine
name.
❖ ❖ ❖ ❖ View settings
msh> devicename
❖ ❖ ❖ ❖ Machine name configuration
m s h > d e v i c e n a m e
"string"
• Enter a machine name using up
to 31 alphanumeric characters.
• Set single names for each ma-
chine.
❖ ❖ ❖ ❖ Machine name initialization
msh> devicename clear name
• Reset the machine name to its
default.
n a m e