Hdoplevel; Positioncorr - Raytheon V8010 Operation Manual

If the unit should be unable to find the satellites for some reason, and the
initialized data has been verified as correct
begin a complete satellite search to refresh the satellite orbit information
in memory by pressing thmkey on the S
To execute the Satellite Search mode, press the(SEARCHTHESKYlsoftkey
followed bypressing the[mkey.AOSEARCHTHESm' or 'SS"message
will appear in the display message windows showing the Search mode is
activated. Once the satellites have been identified and a tixcalculated, ship's
position can be displayed and the unit will be ready for navigation.

352.13 HDOPLEVEL

There may be some periods when the satellite geometry is not ideal for
obtaining the highest
accept the most accurate fixes, medium quality fixes, or all fixes based on
pre-determined HDOP values. To make an accuracy selection,perform the
following steps:
Press thei I%tK)PLEvELIsoftkey repeatedly for the desired selection.
HDOP less than 5
COARSE HDOP less than 20
It is recommended that during the constellation build-up period the
then the FINE level setting should be selected. This is expected to occur
sometime later in 1993 according to the Department of Defense.
To make the HDOP selection, just press the-1 softkey until the
desired HDOP level is highlighted with the bar. PINE is selected when the
bar is completely highlighted.
When the/ POSITION CORR.
his L/L readouts by using any of the following features:
AT
The V8010 can be programmed to only
accuracy
Most Accurate
Medium Accuracy
Less Accurate
SATELLITE STATUS
the receiver can be forced to
ELLITE display.
STATUS
display.
OPERATION 103