Raytheon V8010 Operation Manual page 102

The first MAKE ROUTE screen appears as shown
in the figure.This screen is used to select one ofthe
empty route plans for storing the new route. Use
the A (up) or 'I (down) direction keys to move
the cursor indicator to one of the available route
plans. When the desired number is selected, press
the [q softkey. The MAKE ROUTR display
changes to the LEG assignment layout so you can
easily insert desired waypoint legs into the route
plan.
The MAI(EROUTE (LEGS)
the display, and part of the Waypoint list appearing
in the lowerportion ofthe screen. The boxlabelled
OR" (origin)
is the entry box for typing in the
waypoints that you will insert into the route. It
works this way:
If you already know the waypoint numbers that
you want to use for the route plan you can begin to
insert them following the procedure listed below.
If you're not sure which waypoints to include, just
use the A (up) / V (down) direction keys to
scroll through the waypoint list for the # 's of the
waypoints that you wish to add into the route plan.
To Make the route plan, begin
the number of the starting waypoint (X,X,X). The number you type ap-
"OR " (origin)
pears under the
Now use the 4 (Left) direction key to move leg # 01 over the entry box.
The O
R
repeatingthis sequence a,
key, etc.) until all waypoints of the route have been entered.
Example: PresslO, 2,7, to include wpt # 27 into the route.
If you make a mistake and enter an impossible number, the unit will emit
multiple beeps and the entry box will reset to "
OPERATION 94
be identified
display
can
by
pressing
leg box on the screen.
, , , 4 (Left) key,m,X,X,X, 4 (Left)
X X X
MAKE ROUTE
PRESS MENU TO RETURN
HOME N 42 42.34
W071 25.10
q
OUY N 42 24.43
l wo71 02.15
INC
N 41 41.19
PRESS MENU TO RETURN