Switching The Display Unit On And Off - Raymarine HSB Chartplotter User Manual

14
HSB Series Chartplotter

2.2 Switching the Display Unit On and Off

This section explains how to switch the chartplotter display on and off.
The following description assumes that there is no radar scanner
connected to the chartplotter.
To turn the chartplotter display on, press and hold the POWER key until
the unit beeps. The keys light up and the following caution is displayed:
CAUTION
Raychart chart displays are based on cartographic data that
C-MAP believes to be accurate. However, you should not rely on
these displays as your primary source of navigation. Rather, your
Raychart should be used only as a backup to official government
charts and traditional methods of navigation.
When you have read and understood the caution, press the CONTINUE
soft key. The chart is displayed.
If this is the first time the chartplotter has been turned on, and no chart
card is installed, the display shows the small-scale world map at 0°/0°,
and the default soft keys. Otherwise, the display shows the selected
chart area and any data that were displayed when the display was last
used.
Until unit beeps
D4277-1
To turn the display off, press and hold the POWER key for three
seconds. A countdown timer is displayed; when it reaches zero a beep
sounds, and the display and the key back-lights go off.