5.12.1 Hidden Mma Functions; 5.12.2 Measured Values; Mma Functions Explanation - ESAB Renegade ES 210i Instruction Manual

5 OPERATION

5.12.1 Hidden MMA functions

There are hidden functions in the control panel. To access the functions, press parameter selection
button for 3 seconds (refer to section SETTING PANEL for button placement). The display shows a
letter and a value. Select function by pressing the same button. The knob is used to change the value
of the selected function. To exit hidden functions, press the button for 3 seconds again.
Letter
I

5.12.2 Measured values

Measured current
Measured value in the display for welding current A is arithmetic average value.
Measured voltage
Measured value in the display for arc voltage V is arithmetic average value.
5.13

MMA functions explanation

Arc force
The arc force function determines how the current changes in response to
variations in arc length during welding. Use a low value of arc force to get a calm
arc with little spatter and use a high value to get a hot and digging arc.
Arc force only applies to MMA welding.
Hot start
The hot start function temporarily increases the current in the beginning of the
weld, thus reducing the risk of lack of fusion in the starting point.
Hot start only applies to MMA welding.
0463 856 001
Function
Remote min current
- 22 -
Settings
0-99%
© ESAB AB 2023