Raymarine SportPilot User Manual page 53

48
4. Secure the torque bracket and cable sealing mat to the bulkhead
5. Assemble the SportPilot to the steering shaft.
6. Retain the SportPilot using the split washer and retaining nut.
CAUTION:
Do NOT attempt to support the SportPilot during tightening.
Make sure the torque restraint bolt is removed so the SportPilot
is free to rotate as you tighten the retaining nut. This will prevent
damage to the SportPilot clutch.
7. Tighten the retaining nut to 25 lbft (34 Nm) maximum against the
8. Assemble the steering boss to the SportPilot.
9. Secure the steering boss using the 4 screws and washers.
10. 1 inch (25 mm) steering shafts only:
11. Assemble the steering wheel to the SportPilot.
12. Secure the wheel using the nut and the washer. Make sure that
SportPilot and SportPilot Plus - Owner's Handbook
using the four self tapping screws.
Torque bracket
screw
steering end stop.
• assemble the adaptor collar to the steering boss
• once assembled, fit the Raymarine woodruff key
the woodruff key is fitted before tightening the wheel.
Torque
restraint
Torque
bracket
D1369-2