Chapter 4: Installing the SportPilot
4. Temporarily assemble the torque restraint to the cable holder.
5. Temporarily assemble the cable holder to the SportPilot using the
6. Temporarily assemble the SportPilot to the steering shaft.
7. With the SportPilot aligned vertically and the control stalk
8. Assemble the torque bracket to the torque restraint.
9. Make sure that the lower edge of the torque bracket is level with
screws and washers.
Do NOT tighten the retaining nut at this stage.
pointing to starboard, unfold the torque restraint so it sits firmly
against the bulkhead.
Torque bracket
the bottom of the SportPilot.
Cable
Torque
holder
restraint
Torque restraint
43
D1374-2
D1407- 2