Fitting The Plinth; Oven Check; Customer Care; Thank You - Rangemaster Kitchener 110 Electric Users Manual & Installation

Current Operated Earth Leakage Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
oc ca sion al ly cause nuisance tripping. In these instances
the cooker circuit may need to be protected by fi tting
100mA device. This work should be carried out by a
qualifi ed electrician.
Hobplate
Turn on each plate in turn and check that it heats up

Oven check

The clock must be set to the time of day before the
ovens will work.
Press and hold as above. At the same time, press - or +
until the correct time shows. Don't forget it's a 24 hour
clock.
If you make a mistake or press the wrong button, turn off
the power supply for a minute or two and start again.
Turn on the ovens. Check that the oven fan starts to turn
and that the oven starts to heat up. Turn off the ovens.
INSTALLATION
Check the ap pli ance is electrically safe when you have fi nished.

Fitting the plinth

Fit the inner plinth to the bottom front of the cooker
using the 5 screws provided.
Fit the outer plinth (2 screws 1 each end) to the inner
plinth. The height of the outer plinth can be adjusted by
sliding it up or down via the slotted hole.

Customer care

Please complete your contact details in the front of
this section. Please inform the user how to operate the
cooker and hand over the instruction pack.

Thank you.

23