Electrical Connection - Rangemaster Kitchener 110 Electric Users Manual & Installation

Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the front
bottom corners of the cooker.
Unfold the rear edge of pack base tray. Carefully push
the cooker backwards out of the base pack. Push the
cooker close to its fi nal position, leaving just enough
space to get behind it.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise to
lower.
When you are satisfi ed with the height and level raise
the front of the cooker by one turn of the front roller
adjuster. Screw down the front feet to meet the fl oor.
Screw the front roller adjuster anticlockwise to raise the
front roller so that the front of the cooker is supported
on the feet, not the front roller, to prevent accidental
movement of the cooker.
Leave the levelling tool on the adjuster with the handle
of the tool facing the rear of the cooker, so that the
customer can use it if they wish to move the cooker.
Replace the drawer by locating on side runners and push
in.
INSTALLATION
Check the ap pli ance is electrically safe when you have fi nished.

Electrical Connection

This appliance must be installed by a qual i fi ed electrician
to comply with the relevant In sti tute of Electrical
Engineers (I.E.E.) regulations and also the local elec tric i ty
supply company re quire ments.
Make sure that the mains characteristics (voltage,
nominal, power, etc.) match the ratings indicated on the
data plate affi xed to the lower right hand cooker upright
(remove storage drawer). The cooker is preset for a
single-phase earthed electrical connection. It is essential
to install a multi-pole circuit breaker that completely
disconnects the appliance from the mains, with a
minimum contact break distance of 3mm.
WARNING: THIS APPLIANCE MUST BE EARTHED
The appliance must be connected to an effi cient
earthing circuit. If the electricity network is not equipped
with an earth connection, then it must be installed
separately in compliance with local regulations. Earthing
is a safety measure required by law, and must be
performed with particular care by a qualifi ed technician,
who must also check that the electricity supply
characteristics are correct.
The cable size used should be suitable for the appliance
load and in accordance with local regulations. Please
note the maximum cable sizes are 6mm
terminals and 10mm
Access to the mains terminal is gained by removing
the electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for your
electrical supply type (see fi g.).
Check that the links are correctly fi tted and that
the terminal screws are tight.
Secure the mains cable using the cable clamp.
22
2 for the screw
2 for the 3 pronged links.