Door Adjustment; Oven Check; Fitting The Plinth; Customer Care - Rangemaster Kitchener 90 Dual Fuel Users Manual & Installation

Hotplate
Check each burner in turn. Push in tap and turn to the
large fl ame symbol. Press ignition switch on facia panel..

Oven check

The clock must be set to the time of day before the left
hand Main oven will work.
Press and hold as above.
At the same time, press - or + until the correct time
shows.
Don't forget it's a 24 hour clock.
If you make a mistake or press the wrong button, turn off
the power supply for a minute or two and start again.
Turn on the ovens. Check that the oven fans start to turn
and that the ovens start to heat up. Turn off the ovens.

Fitting the plinth

Fit the inner plinth to the bottom front of the cooker
using the 5 screws provided.
Fit the outer plinth (2 screws 1 each end) to the inner
plinth. The height of the outer plinth can be adjusted by
sliding it up or down via the slotted hole.
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
INSTALLATION

Door adjustment

Please check the aligment of the doors. The left hand
Main oven has adjustible hinges
To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge fi xing screws and use the
notch and a fl at bladed screwdriver to move the position
of the hinge to set the hinge position.
Retighten the hinge screws.
Eff ect of hinge adjustment – exaggerated for clarity
Oven door omitted for clarity

Customer care

Please complete your contact details in the front of
this section. Please inform the user how to operate the
cooker and hand over the instruction pack.

Thank you.

26
Centre line of hinge pin