Rangemaster Kitchener 110 Electric Users Manual & Installation page 26

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
13. To Change Oven Door Seal
Open oven door. The seal is held in place by small hooks
on the rear face. At the corner pull seal diagonally away
from the door centre until that hook is released. Proceed
to the next hook and release it in a similar way, and so
on. Use force if the hooks are stiff , as the old seal will be
discarded.
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of
the door, and proceed round the door snapping in each
hook in turn.
14. To Adjust Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep, and
screw in or out as required until required fi t is obtained.
Retighten locking nut.
15. To Remove Fan Oven Inner Back.
Open RH oven door and remove the screws and washers
securing the inner back to the back of the oven.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the 4 screws and washers are
fully tightened. .
16. To Change Fan in RH Oven.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected to
the fan noting their position. Remove oven inner back
(see 15). Hold the fan blade and remove the centre nut
(left hand thread) 2 brass washers, fan blade and Circlip.
Unscrew fan retaining nuts and washers (3 off each) and
lift the fan away from the rear of the cooker. Fit new fan
and reassemble in reverse order. Check operation of
oven.
17 To Remove an Oven element Thermal Cut-Out.
Disconnect from the electricity supply.
Pull the cooker for ward to gain access to the cover
box. Undo the cover screws and lift clear. The cutout
is located on the earth plate be side the oven element
con nec tions. Disconnect the cutout wir ing. Undo the
fi xings that secure the cutout to the earth plate and
re move. Fit re place ment control and re-as sem ble in
reverse order.
18. To Remove RH Oven Element.
Disconnect from electricity supply.
Remove oven inner back (see 15).
Remove 2 screws from the top of the element and 1 from
the bottom of the element in side the oven. Lift element
out carefully, disconnect the terminals connected to
the element noting their positions. If it is not possible
to disconnect the leads in this way, pull cooker forward
to gain access to the rear, remove screws securing the
electric cover to the back sheet and remove cover and
disconnect the terminals from the rear.
Fit new element, and reassemble in reverse order. Check
operation of oven.
26