Rangemaster Kitchener 110 Electric Users Manual & Installation page 25

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
to the control panel by fi rst lining up the raised key on its
body with the cut-out in the control panel and pushing it
in from the front. Assemble the new switch to the bezel
by lining up the key sections and pushing home. Fit the
new button by pushing in from the front.
Replace control panel in reverse order and test for
correct operation.
6. To Remove Electronic Timer
Disconnect from electricity supply.
Pull off the timer control buttons and remove the control
panel (See 4). Remove the timer/mounting bracket
assembly from the control panel by removing the two
fi xing screws. Remove the timer from its mounting
bracket by depressing the plastic lugs on the timer case,
at the same time pulling the unit forward.
Reassemble in reverse order. When replacing leads refer
to the wiring diagram. Check operation of timer.
7. To Remove a Thermostat
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Open appropriate oven door and remove
oven furniture.
RH oven
Remove thermostat phial cover (2 screws). Unclip
the thermostat phial from the clips in the oven
back.
LH oven
Pull cooker forward to gain access to the cover
box at the rear of the cooker. Remove the screws
securing the cover and lift clear.
Feed the thermostat capillary out of the oven.
Disconnect wiring from thermostat. Remove 2 screws
holding thermostat to mounting panel. Fit new
thermostat and reassemble in reverse order. Ensure
that the phial is clipped to the oven back with the phial
centrally positioned between the clips.
Check operation of thermostat.
8. To Change Grill Controller
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Disconnect wiring from controller. Remove
2 screws holding controller to mounting panel. Fit new
controller and reassemble in reverse order. Check for
correct operation.
9. To Remove Grill Door
Remove the left hand side panel (see 1). Remove the
control panel (see 4). Remove the centre cover strip (5
screws, 2 top, 2 bottom, 1 in middle). Remove the two
countersunk screws (1 each side) securing the grill hinge
arms to the front of the grill chamber.
NOTE: The arms are spring tensioned. Carefully remove
the grill door. Retain the gaskets.
Reassemble in reverse order ensuring that the gasket is
fi tted between the hinge arm and the front of the grill
chamber.
10. To Remove an Oven Door
Open oven door and remove Handyrack (where fi tted)
by springing one side out of the bracket on the door and
sliding the other side free. Support the door and remove
the two screws securing the upper hinge and packing to
the cooker front. Remove the door from the lower hinge
by lifting slightly and moving outwards.
Reassemble in reverse order.
11. To Change Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fi xing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove door handle from panel by unscrewing 2
retaining nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
12. To Change Oven Door Latch
Remove outer door panel (see 15). Remove screws 'B'
holding latch assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
25