Basta Boatlifts 2x2k50 Manual page 13

CONNECT POWER UNIT
11
Complete Power Unit Package
FEMALE
QUICK COUPLER
Step 1: Slide the Hydraulic Hose Assembly through the
access hole in the side of the fiberglass enclosure and
attach the ends to their corresponding Quick Couplers.
Ensure each Quick Coupler is fully seated, tight and
with no gap at the connection joint. Complete for each
set of hoses.
Step 2:
Remove shipping plug in hydraulic reservoir and
replace with breather plug before first use.
Step 3:
Install Battery as shown. Connect the Red Battery
Cable to the positive terminal (+) and the Black
Battery Cable to the negative terminal (-).
Step 4:
Before moving into the water, test the lift on dry
ground using the Up/Down Switch and the Key Fob
Transmitters. Inspect the system for leaks.
MALE
QUICK COUPLER
NEGATIVE BATTERY CABLE
LIFT 1
SWITCH
LIFT 2
SWITCH
HOSE ASSEMBLY
(BLACK)
POSITIVE BATTERY CABLE
The control unit contains two
separate lift control com-
puters. Up to 4 fobs may be
enrolled for each lift.
IMPORTANT
ONLY ADD FLUID WITH LIFT IN
DOWN POSITION
Hydraulic fluid shown with lift in the
DOWN position
BREATHER CAP
(RED)
1"
one
inch
PAGE 13