Page 2
The lift should not be used for any other Use a mooring line for additional security. purpose besides the lifting of boats & watercraft. MAXIMUM CAPACITY Only use Basta Boatlifts biodegradable non-toxic 7,000 lb hydraulic fluid - part # Y354-0001. 3,175 kg...
OIL INJECTED INTO THE SKIN FROM HIGH PRESSURE LEAKS IN HYDRAULIC SYSTEMS CAN CAUSE SEVERE INJURY. SEEK MEDICAL ATTENTION IMMEDIATELY. USE ONLY BASTA BOATLIFTS BIODEGRADABLE HYDRAULIC FLUID After the lift is assembled and installed, all fasteners should be checked for proper tightness and reinspected periodically.
Page 4
FORWARD Model # 7k Part # A207-6401 Model # 7k Part # A207-5101 Assembly Item List Note: Items A-G referred to as sets (i.e., C = bolt, washer, nut) PART # ITEM # DESCRIPTION PART # ITEM # DESCRIPTION S103-0919 Hex Cap Screw 3/4 x 8-1/2 SS W110-0017 Aft Crossmember...
Page 5
SEE PAGES 12-13 FOR ELECTRICAL AND HYDRAULIC PARTS Pre-installed Pre-installed...
Page 6
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS NOTE: use a small amount of 'moly' lube on bolt threads NOTE: assemble lift on level ground. NOTE: tighten set screws A & B alternately to push leg securely into corner of leg socket...
Page 7
NOTE: do not tighten bolts completely until the H-frames and bunks have been installed and squared up in Step 8 NOTE: do not tighten bolts completely until the H-frames and bunks have been installed and squared up in Step 9...
Page 8
ASSEMBLY INSTRUCTIONS NOTE: use a small amount of 'moly' lube on bolt threads NOTE: remove ties...
Page 9
- USE TOP HOLES - USE BOTTOM HOLES FORWARD NOTE: remove ties...
Page 10
ASSEMBLY INSTRUCTIONS NOTE: use a small amount of 'moly' lube on bolt threads Install cylinder with lift in 'down' position and with hose fittings facing toward power unit box...
Page 11
NOTE: after bunks are installed, adjust the base frame to be square and level, then tighten bolts left loose in steps 2 & 3 NOTE: remove ties Install bunks with lift in 'down' position (Illustration shows lift in 'up' position for visual clarity) BOLT BOLT BOLTS...
Page 12
CONNECT POWER UNIT FEMALE QUICK COUPLER DO NOT SUBMERSE H700-0019 COMPLETE POWER PACKAGE Keep inside dry H653-0013 Prevent unauthorized use - KEEP BOX LOCKED up/down switch power NOTE: NOTE: switch REMOVE SHIPPING PLUG IN REMOVE SHIPPING PLUG IN solar RESERVOIR AND REPLACE RESERVOIR AND REPLACE controller WITH BREATHER PLUG...
Page 13
POWER SYSTEM COMPONENTS SOLAR PANEL ASSEMBLY R281-0004 Padlock not included ENCLOSURE C243-0003 NOTE: NOTE: REMOVE SHIPPING PLUG IN REMOVE SHIPPING PLUG IN RESERVOIR AND REPLACE RESERVOIR AND REPLACE WITH BREATHER PLUG WITH BREATHER PLUG BEFORE START-UP BEFORE START-UP CONTROL PANEL ASSEMBLY R815-0008 pre-wired...
Page 14
AGM type batteries are sealed and do not require maintenance. The hydraulic fluid level should be about one inch below the top of the reservoir with the lift DOWN. DO NOT add fluid with the lift in the raised position! Use only Basta Boatlifts biodegradable non-toxic hydraulic fluid.
Page 15
Always leave the boat in the fully raised, Over-Center™ for the environment. This fluid is different than food-grade oil. Only use Basta Boatlifts fluid in your hydraulic system. position with the power off. Q: WHAT IF I GET A NEW BOAT? A new lift Re-leveling the boat lift may be necessary.
Page 16
Products. on the water. Welcome to the Basta Boatlifts family and Boat Happy! Labor for warranty work to be provided by the Company’s Authorized dealer for a period of 3 years from Warranty Start Date, provided there is an active Authorized Basta Inc.
Need help?
Do you have a question about the Over-Center 7k51 and is the answer not in the manual?
Questions and answers