urmet domus Mininote+ 1722/85 Installation Manual page 7

All manuals and user guides at all-guides.com
It is always possible to go back to a higher level menu by pressing the 'OK' or 'BACK' button.
Similarly, with a Yokis Remote control, a 'Reset' to initial settings for a specific button (and for that
button only) can always be controlled. The icon to use to control a button reset is located at the top
right. A single button resetting will not change the button icon and name.
It opens a sub-menu designed to 'Connect' the button to one or more receivers.
Connect (or disconnect) E5 R1
It can be used to 'connect' the button to a receiver.
In the Direct mode, one or more receivers can be connected, up to a maximum of 4 (if a fifth
receiver is connected, this will replace the fourth).
In the Radio Bus mode, typically only one is connected.
For more information, refer to the Yokis 'Radio Quick Installation Guide', sect. 'A-1: Connecting a
transmitter to a receiver'.
The button can also be used to perform the 'disconnecting' procedure: sect. 'A-3: Disconnecting a
transmitter from a receiver'.
The other 2 menu items are used less frequently:
Set Radio Bus Acces Points E7 R1
Useful when you wish to control a specific remote receiver (or even more than one), located on
Radio Bus.
More information in 'E: Range extension with RADIO BUS' and 'E-1: Definition of an Access Point
to the Radio Buso' of the Yokis 'Radio Quick Installation Guide'.
WARNING! in the event of a mistake, it is not possible to only delete the specific Access Points of
one button. In this case, all the Access Points of all the buttons on the monitor must be deleted at
the same time.
DS1722-090 LBT20157
7