Table of Contents
Advertisement
Reference should be made to section 'G – Pushbutton functions' of the Yokis 'Radio Quick
Installation Guide'.
This option can only be used if a Button had been 'connected' to a single receiver module. In this
case, it is then possible to configure the receiver with specific sequences of pulses.
Using the keypad, the number of pulses to be sent to the Receiver Module with that specific button
can be defined. E.g. to configure the timing of the receiver. Then press 'Send' and wait for a
notification from the receiver, typically displayed on the receiver (blinking or small movements).
Please refer to the individual Receiver Modules manuals for possible controls.
For example, if an MTR2000ER relay module was 'connected' and you wish it to have a 15
minutes' timed output (e.g. for irrigation of a garden), then:
-
Send 23
(E
23) to unlock the module configuration and wait to see 3 flashes on the
receiver.
-
Send 27
(E
27) to switch the module to the timer mode and wait to see 7 flashes on the
receiver.
-
Send 26
(E
26) to configure the duration in minutes and wait to see 6 flashes on the
receiver.
-
Send 14
(E
14) to configure a 15-minutes' timed interval and wait to see 4 flashes on the
receiver.
-
Send 21
(E
21) to lock the module configuration and wait to see 1 flash on the receiver.
While if you wish the MTR2000ER connected module to work in impulsive mode (i.e. the module
generates a 0.5 seconds' pulse each time that the button is pressed), for example to control the
opening of a gate, then:
-
Select the mode 'M' by sending 10 pulses:
-
Send 16 (16) to configure the IMPULSIVE mode and wait to count 6 confirmatory flashes
on the monitor LED.
NOTE: as was mentioned here above, receiver module configuration only works if the button has
been connected to a single receiver module.
DS1722-090
All manuals and user guides at all-guides.com
M
10
LBT20157
Advertisement
Table of Contents
