Kenmore 111.72695120 Service Manual page 54

10. Disassemble/Assemble Procedures
10-1. Holder Water Filter Assembly
Step
Turn off the main water supply to the appliance.
1
2
3
4
□ Remark :
• Remove any residual matter inside the water supply line after installation.
1) Turn on the main water supply to the refrigerator .
2) Dispense water using dispenser for approx.10min to clean water and remove air from the lines.
3) And then check there are no water leaks or drips coming out from the water filter and dispenser.
4) If necessary, run water through the dispenser more.
To avoid risk of electrical shock that can cause death or severe personal injury,
WARNING
!
disconnect unit from power before servicing unless tests require power.
Description
Separate the tube
fixture on the upper left
side cabinet back face.
Separate the tube
fixtures, if necessary.
Remove ¼" tube connected
to water filter outlet from the
water valve while pressing
the part (A). Remove the
locking clip before pushing
the part.
See the left figure.
※ Follow the reverse order when assembling.
Step
5
6
Pull down the Holder Assembly and tubes gently
to remove.
①
① Gray 1/4" – Water Filter Outlet
② 5/16" – Water Tank Inlet
③ Blue 1/4" – Ice Maker Tube
Description
Remove a screw
②
③
54 / 69