WAGNER W 600 FLEXIO 18V Manual page 48

EN
Problem Problem
Coating material
drips from the
nozzle
Atomisation too
coarse
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose
Poor covering
capacity on the wall
40
Cause Cause
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
•
Coating material too thick
•
Material volume too large
•
Nozzle clogged
•
Air cap assembled incorrectly
•
Air filter heavily soiled
•
Too little pressure build-up in
container
•
Amount of air too low
•
Coating material in container
running out
•
Air filter heavily soiled
•
Nozzle seal is missing or worn
•
Too much coating material
applied.
•
Distance to the object too large
•
Too much coating material
applied
•
Amount of air too high
•
Diaphragm soiled
•
Diaphragm defective
•
Spray material is too cold
•
Highly absorbent surface or paint
with poor covering capacity
•
Distance too large
W 600 Flexio 18V
Remedy Remedy
•
Tighten
•
Change
•
Change
•
Clean
•
Dilute
•
Reduce the material
volume
•
Clean
•
Snap air cap properly
into place (fig. 19, 2)
•
Change
•
Tighten container
•
Increase air quantity
•
Refill
•
Change
•
Change
•
Reduce the material
volume
•
Reduce distance
•
Reduce the material
volume
•
Decrease air quantity
•
Clean the diaphragm
•
Replace the diaphragm
•
The material you are
spraying should be at
room temperature
•
Cross spray (Fig. 13)
•
Closer to the object