Preparation Of The Workplace (For Interior Wall Paint); Charging - WAGNER W 600 FLEXIO 18V Manual

W 600 Flexio 18V

7. Preparation of the workplace (for interior wall paint)

Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Mask all the areas and objects that are not to be spray painted, or
remove them from the work area. No liability is assumed for damage
due to overspray. Silicate paint corrodes glass and ceramic surfaces
upon contact! All such surfaces must therefore be completely covered.
Pay attention to the quality of the adhesive tape used.
i
Do not use excessively strong adhesive tape on wallpaper and painted
surfaces, in order to avoid damaging these surfaces when removing the
tape. Remove adhesive tape slowly and evenly; do not use jerky movements.
Do not leave adhesive tape on surfaces any longer than necessary, in order
to minimise the possibility of residues when removing.
Also observe the adhesive tape manufacturer's instructions.

8. Charging

Before connecting to the mains, make sure that the
mains voltage corresponds to the specification on the
charger's rating plate.
1. Plug the mains plug of the charger into the
socket (the battery charging indicator (9) lights
up constantly).
2. Insert the battery into the charger, the battery
charging indicator (9) starts flashing.
If the battery charge indicator lights up constantly when the battery is inserted,
i
the battery is either fully charged or overheated and must first cool down.
3. Once the battery is fully charged, remove the battery from the charger.
4. Unplug the mains plug of the charger from the socket.
Battery indicator
Green = Sufficient battery charge
Orange = Only minor work still possible
Flashing = Battery must be charged
orange
9
8
EN
31