In-Band Remote Management - Newtec MDM9000 User Manual

Feature Descriptions

16.15 In-band Remote Management

Use this feature to manage remote devices over the satellite link.
A user plane configuration model is introduced allowing the operator to manage remote Newtec
devices but also other third party equipment.
The configuration offers the full flexibility of the user plane including ACM.
The configuration is done via the existing management model for user traffic. The user traffic
management model is extended as follows:
• The classification expression in the encapsulator is extended, to contain classify traffic from a
different virtual network:
"vnet management and ip4 dst host 1.2.3.4" is an example how you can select traffic from the
management network.
• The decapsulation channel has a new attribute, the "virtual network".
By default the traffic network is used. When doing remote mgmt, you have to specify the
"management" virtual network.
The following figure shows a principle drawing of the remote management feature in a point to point
link.
The remote management feature only works in a Layer 3 setup! (The data traffic plane
can be in Layer 2 or Layer 3.)
Make sure that during configuration the "temporary Mgmt PC" on the remote site is in
the same subnet as the MDM9000. When the "temporary Mgmt PC" is in a different
subnet the connection is lost when the Mgmt Gateway of the MDM9000 is set to
0.0.0.0.
(Note: the gateway is set to 0.0.0.0 because you want to route the mgmt traffic to the
satellite.)
Newtec Proprietary
Confidentiality: Unrestricted
MDM9000 Satellite Modem
R3.2_v1.0
/
270 387