Management Using The Ethernet Interface; Cabling; Settings - Newtec AZ420 User Manual

How to manage
4.3

Management using the Ethernet Interface

4.3.1

Cabling

Use a crossed network cable for a direct connection between the Ethernet port of
the demodulator to the Ethernet port of a computer. In case connection to the
demodulator is done via a hub or switch, straight network cables are used.
4.3.2

Settings

The platform is equipped with a powerful and easy-to-use graphical user interface
(GUI) that allows you to remotely monitor and control your equipment through a
web browser.
To use the web interface, adapt the TCP/IP properties of the computer so you can
manually set an IP address that is within the range of the device IP address. For
example: take IP address 10.0.0.2 on the computer and 10.0.0.1 on the device.
Make sure that no pop-up blockers or firewall are active!
To adapt the TCP/IP properties on a typical Windows computer:
 Choose Start > Connect To > Show all connections.
 Right-click Local Area Connection.
 Click Properties.
 Scroll down and click Internet Protocol (TCP/IP).
 Click Properties.
 Choose Use the following IP address.
 Enter the following data:
­ IP address, for example:10.0.0.2.
­ Subnet mask, for example: 255.255.255.0
version 2.0
21
User Manual for AZ420 Telco Satellite Modem
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS