Planet WBS-900AC-KIT User Manual page 45

Object
Enable SSH
SSH port
Enable Telnet
Telnet port
Enable HTTP
HTTP port
Note: HTTPS is always enabled through the standard port 8080 connection.
SNMP
SNMP is a standard protocol widely used for remote network management over the Internet. After enabling
SNMP, the CPE device will act as an SNMP agent. The SNMP agent provides a device monitoring interface
using the Simple Network Management Protocol, allowing network administrators to monitor network
performance, detect and resolve network problems.
Object
Enable SNMP
R/O community
Enable Telnet
Telnet port
Enable HTTP
HTTP port
Description
Enable or disable access to the device through SSH.
Specify the SSH service port. The default SSH port is 22.
Enable or disable access to the device through Telnet (factory
default is disabled).
Specify the remote login port. The default Telnet port is 23.
Select the switch to enable or disable HTTP access to device
management.
Specify the HTTP port. The standard HTTP port is 80.
Figure 5-27 SNMP Configuration
Description
Specify the SNMP service status.
Specify the read-only community name for SNMP version 1 and
version 2c. The read-only
administrators to read values but denies any attempts to change
them. Ping Watchdog.
Enable or disable access to the device through Telnet (factory
default is disabled).
Specify the remote login port. The default Telnet port is 23.
Select the switch to enable or disable HTTP access to device
management.
Specify the HTTP port. The standard HTTP port is 80.
-37-
User Manual of WBS-900AC-KIT
community allows CPE unit