Planet WBS-900AC-KIT User Manual page 38

Wireless Mode: Station (WDS/TDMA3)
The page includes the following fields:
Object
Enable Radio
Country
Tx power (dBm)
ATPC
Channel
Max data rate, Mbps
Figure 5-17 Wireless Station Configuration
Description
Enable or disable the CPE wireless switch.
Display the country in which the CPE bridge is operating.
The country selection determines the
frequencies, and transmission power levels based on regulatory
restrictions in the operating country. The country is selected during
the initial CPE device installation, but can be updated if necessary.
Set the transmission power level when the device transmits data.
The farther the distance is, the more transmission power is
required. Use the slider or enter a value manually to set the
transmission power level. When a value is entered manually, the
slider position changes based on the input value. The maximum
transmission power level is limited to the value allowed by the
regulatory agency in the country where the device is operating.
Select whether to enable automatic transmit power control (ATPC).
If enabled, the CPE wireless will continually communicate with the
remote device to automatically adjust the best transmission power.
Display the channel on which the AP is operating, or click to use the
automatic channel function. Clicking the button displays the
channel selection window.
Select the maximum data rate at which the AP should transmit data
packets (in Mbps). The AP will attempt to transmit data at the set
maximum data rate. If interference occurs, the CPE will fall back to
-30-
User Manual of WBS-900AC-KIT
available channels,