Planet WBS-900AC-KIT User Manual page 35

The page includes the following fields:
Object
Enable Radio
Country
Tx power (dBm)
ATPC
Channel
Max data rate, Mbps
AMSDU
Description
Enables or disables the CPE wireless switch.
Displays the country in which the CPE bridge is operating.
The country selection
frequencies, and transmission power levels based on regulatory
restrictions in the operating country. The country is selected during
the initial CPE device installation, but can be updated if necessary.
Sets the transmission power level when the device transmits data.
The farther the distance is, the more transmission power is required.
Use the slider or enter a value manually to set the transmission power
level. When a value is entered manually, the slider position changes
based on the input value. The maximum transmission power level is
limited to the value allowed by the regulatory agency in the country
where the device is operating.
Selects whether to enable automatic transmit power control (ATPC).
If enabled, the CPE wireless will continually communicate with the
remote device to automatically adjust the best transmission power.
Displays the channel on which the AP is operating, or click to use the
automatic channel function. Clicking the button displays the channel
selection window. (See figure 5-14)
Select the maximum data rate at which the AP should transmit data
packets (in Mbps). The AP will attempt to transmit data at the set
maximum data rate. If interference occurs, the CPE will fall back to
the highest rate at which data transmission is allowed. Only
applicable to 802.11a or 802.11a/n IEEE mode.
Enable AMSDU packet aggregation. If enabled, the maximum size of
the 802.11 MAC frame will be increased. Only applicable to 802.11n
or 802.11a/n IEEE mode.
Figure 5-14 Channel Table
-27-
User Manual of WBS-900AC-KIT
determines the available channels,