Planet WBS-900AC-KIT User Manual page 37

The page includes the following fields:
Object
SSID
Broadcast SSID
User isolation
Business VLAN ID
Maximum client connection
number
Minimum client signal, dBm
Management over wireless
Multicast enhancement
Description
Specify the unique name of the wireless network device. The
device will broadcast this SSID message to all radios within range,
promoting it.
If this option is disabled, the CPE device will not broadcast its SSID
to workstation devices.
Select Layer 2 isolation to prevent client-to-client communication.
Specify the VLAN ID that traffic is tagged for on a specific VAP
interface. Devices associated with a specific SSID will be grouped
into this VLAN. Mapping to the data VLAN ID is not available if the
device is running in router network mode.
Specify the maximum number of wireless clients associated with
the AP radio.
If enabled, the AP will disconnect clients with a signal lower than
the configured threshold.
Control wireless management access. For security reasons, it is
recommended to disable wireless access and use Ethernet cable
for physical network connection to manage CPE access. Wireless
management is not available if the device is running in router
network mode.
If clients do not send IGMP (Internet Group Management Protocol)
messages, they will not register as recipients of multicast traffic.
With IGMP listening, the multicast enhancement option isolates
multicast traffic from unregistered clients and allows devices to
send multicast traffic to registered clients at higher data rates. This
reduces the risk of traffic overload on PtMP links and increases the
reliability of multicast traffic as packets are retransmitted if the initial
transmission fails. If clients do not send IGMP messages but should
receive multicast traffic, you may need to disable multicast
enhancement. This option is enabled by default.
-29-
User Manual of WBS-900AC-KIT