Related Manuals for OPTO-EDU A18.1828
Summary of Contents for OPTO-EDU A18.1828
- Page 1 A18.1828 Comparison Microscope Instruction Manual To ensure the safety and obtain satisfactory performance, please study this instruction manual thoroughly be fore start to use the instrument.
-
Page 2: Technical Parameters
Model A18.1828 Comparison Microscope is a new generation product of our long-time experience and technical innovation. With our success in solving the technical problem of the adjustability of its separation line width, its quality has, therefore, reached the international advanced standard. - Page 3 Fig.1 1. Total switch 8. Six-holes nosepiece 2. Light adjusting knob 9. Separation line window 3. Coarse adjusting focus knob 10. Separation line adjusting knob 4. Horizontal linkage knob 11. Video recording tube 5. Working table lifting knob 12. CCD (option) 6.
- Page 4 15.Eyepiece 23. Control panel 16. Binocular head 24. Polarizer 17. Bridge body 25.Anlayser 18. Air-blast light source 26. Coaxial light 19. Rotating ,tilting table plate 27. 0.4X objective 20. Horizontal working table 28. Green filters 21. X-axial movement knob 29. Red filters 22.
- Page 5 cold light source(7). 2.View-speed adjustment : Fix up eyepiece, drive binocular head(16) to adjust interpupillary distance, shown as Fig.2 Fig.2 3.Horizontal working table: Place some specimen on two table plates, separately drive left and right lifting knob(5) to keep the image clear. For moving left and right the stage, rotate the knob(21);...
- Page 6 magnification. In order to observe a large viewfield, set 0.4X low-magnification objective to the whorl (at the downside of objective) and then renew focusing . Fig.4 To order to keep both left and right objective at the same magnification, the operator must make focusing by the following methods : separately place the magnification reticles(30) on two table plates, and view them through eyepieces until two reticles’...
- Page 7 To observe large cartridge case To observe irregular object Fig. 5 7.Video recording: For video recording , fit up video recording tube(11), on which the CCD (12) is fixed, and then use special video wire, connect to monitor(or computer), push in the lever, the operator may observe an image on screen. 8.
- Page 8 Fig.7 11.Power source: All electric parts are built into the base of instrument. If there is some wrong with the instrument , firstly check the fuse at the back of base. Any further examination or repair which might become necessary should be entrusted to our factory or other special department.
-
Page 9: Packing List
A18.1828 Packing List Mainbody 1 pcs Video Adapter 0.5x 1 pcs Binocular head 1 pcs Photography tube 1 pcs 10X Eyepiece 2 pcs Photo adapter 1 pcs 20X Eyepiece 2 pcs 12V50W halogen lamp 2 pcs Objective 0.5x, 1x, 1.5x, 2x, 4x, 6x... - Page 10 www.cnoec.com.cn Page 9 of 10 sale@cnoec.com...