ADJ UB 12H User Manual page 15

P R I M A R Y- S E C O N D A R Y C O N F I G U R AT I O N
This function allows units to be linked together to run in a Primary-Secondary set up, in which one unit
will act as the controlling unit and the others will react to the controlling unit's built-in programs. Any unit
can act as a Primary or as a Secondary, but only one unit can be programmed to act as the Primary.
Connections and Settings:
1. Daisy chain your units together via the XLR connectors on the rear of each unit. Use standard XLR
data cables to link your units together. Remember that the male XLR connector is the input, and
the female XLR connector is the output. The first unit in the chain (primary) will use the female XLR
connector only, while the last unit in the chain will use the male XLR connector only.
2. Set the "Primary" unit to your desired operating mode, then connect the "Secondary" unit or units.
3. For the "Secondary" unit(s), press the MODE button until "SEcd" is displayed. The "Secondary"
unit(s) will now follow the "Primary" unit.
M U LT I P L E U N I T P O W E R L I N K I N G
This feature allows the fixtures to be linked to one another using the power input and output sockets.
The maximum number of fixtures that can be linked in this manner is as follows:
• 7 units @ 120V
• 13 units @ 240V
After this number has been reached, a new power socket will be required in order to accommodate
additional fixtures.
NOTE: USE CAUTION WHEN POWER LINKING FIXTURES OF DIFFERENT MAKE AND MODEL
TYPES, AS THE POWER CONSUMPTION OF OTHER LIGHTING FIXTURES WILL VARY FROM
MODEL TO MODEL!
15