Advertisement
O P E R AT I N G I N S T R U C T I O N S
LED Display On/Off:
To set the LED display to turn off after 10 seconds of inactivity, press the MODE button until "don" is
displayed, then press the UP button to toggle the display to "doff". Now the display will disappear after
10s of inactivity. Press any button to turn the display on again.
LED Display Inversion:
Follow these instructions to flip the display 180° so that the display can be read upside down.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either "on"
or "oFF".
2. Press the SET UP button until "Stnd" is displayed.
3. Press the UP or DOWN buttons to "flip" the display 180°.
Operating Modes:
This unit has 6 operating modes to choose from:
•
Static Color Mode - Choose 1 of 63 color macros.
•
RGBWA+UV Dimmer mode - Choose one of the six colors to remain static, or adjust the intensity of
each color to make a custom color.
•
Built-In Program - There are 22 built-in programs to choose from with multiple adjustments.
•
Auto Run - An automatic program will run with adjustable fade speed and strobe.
•
Sound Active mode - The unit will react to sound, chasing through the built in programs.
•
DMX control mode - Control each individual fixture trait with a standard DMX 512 controller.
Static Color Mode:
1. Plug the fixture in and press the MODE button until "CLxx" is displayed.
2. Select your desired color from the 63 available optionsby pressing the UP and DOWN buttons.
3. Press the SET UP button to enter the Flash (Strobe) setup mode. "FS.xx" should now be displayed
on the screen. Adjust the flash/strobe to your desired value. "FS.00" turns flash/strobing off, while
"FS.15" is the fastest strobe speed.
RGBWA+UV Dimmer Mode:
In this mode you can select and adjust the intensity of the red, green, blue, white, amber, or UV colors
to create a custom color.
1. Plug the fixture in and press the MODE button until one of the color options is displayed. The default
selection is red, which will display as "r.xxx".
2. Cycle through each color dimming mode. Use the UP and DOWN buttons to adjust intensity, then
press SET UP to cycle to the next color dimming mode. Colors are indicated as follows:
•
r.XXX = Red Dimming Mode
•
G.XXX = Green Dimming Mode
•
b.XXX = Blue Dimming Mode
•
U.XXX = White Dimming Mode
•
A.XXX = Amber Dimming Mode
•
u.XXX = UV Dimming Mode
3. Next, activate strobing by pressing the SET UP button to enter the strobe mode. "FSXX" will be
displayed, indicating that the unit is in strobe mode. The strobe can be adjusted between "FS.00"
(flash off) to "FS.15" (fastest flash).
11
- Quick Links:
- DMX Set up
Hide quick links:
Advertisement
