KTM 450 SX-F 2023 Owner's Manual page 72

11 SERVICE WORK ON THE CHASSIS
70
–
Position the foot brake cylinder.
Push rod
Info
Ensure that the dust boot is correctly seated.
–
Mount and tighten screws
Guideline
Remaining screws,
S05389-10
chassis
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever on
angle lever
Info
Pay attention to flat area
S05348-10
–
Mount and tighten screw
Guideline
Screw, bottom
shock absorber
Info
Raise the link fork slightly to be able to mount the
screw more easily.
–
Position the left frame protector.
–
Insert the right frame protector from below and push it to the
rear.
–
Mount and tighten screws
Guideline
Screw, frame protec-
tor
–
Mount the new cable ties.
S05384-11
Finishing work
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
–
Install the main silencer. (
4
engages in the foot brake cylinder.
5
.
M6 10 Nm (7.4 lbf ft)
6
.
M16x1.5 60 Nm (44.3 lbf ft)
B
.
7
.
M10 60 Nm (44.3 lbf ft)
8
with the washers.
M5 3 Nm (2.2 lbf ft)
p. 77)
Loctite ® 2701™
p. 99)
p. 53)