KTM 450 SX-F 2023 Owner's Manual page 136

17 SERVICE WORK ON THE ENGINE
134
–
Position long oil screen
–
Position the pin wrench through the drill hole of the screw plug
in the opposite section of the engine case.
–
Push the oil screen all the way into the engine case.
F03776-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil
screen
–
Mount and tighten oil drain plug
new seal ring.
Guideline
Oil drain plug with
H05065-10
magnet
–
Remove screws
ring.
H05066-10
–
Pull oil filter
Lock ring plier (51012011000)
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surfaces.
H05067-10
–
Lay the motorcycle on its side and fill the oil filter housing to
about ⅓ full with engine oil.
–
Place the oil filter into the oil filter housing.
–
Lubricate the O-ring of the oil filter cover and mount it with oil
7
filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
H05068-10
–
Stand the motorcycle upright.
4
with the O-rings on a pin wrench.
3
with the O-ring.
M20x1.5
1
with the magnet and a
M12x1.5
5
. Take off the oil filter cover with the O-
6
out of the oil filter housing.
.
M6
15 Nm (11.1 lbf ft)
20 Nm (14.8 lbf ft)
10 Nm (7.4 lbf ft)