Renishaw RTS Quick Start Manual page 24

Changing the probe settings (when using with a RMI-QE)
Probe settings can be changed using Trigger Logic™.
1
2
3
> 5 s
Key to the symbols
LED short flash
LED long flash
Deflect the stylus for less than 4 seconds
to move to the next menu option.
Deflect the stylus for more than 4 seconds
to move to the next menu.
To exit, leave the stylus untouched for
more than 120 seconds.
To exit, leave the stylus untouched for
more than 20 seconds.
CAUTION: Do not remove the batteries whilst in configuration
mode. To exit, leave the stylus untouched for more than 20
seconds.
24
LED check
Deflect the stylus and hold it
deflected until after the battery
status has been displayed at the
end of the review sequence.
Battery good
To partner the probe and/or change the
probe settings, go to the next page
Battery status
Battery low
or
.