Table of Contents
Advertisement
The RWP55 Series hydraulic pumps are designed to have a maximum of 690 bar (10,000 psi) at a flow rate of 902
cc/min (55 cu� in/min) maximum� Note that Certain pump configurations, addition of accessories, and air line
sizes may affect the flow� All pumps are supplied fully assembled, ready for operation, but without oils/fluids�
The air/hydraulic versions of the RWP55 Series start
under full load and are suitable for operation up to 345
or 690 bar (5,000 or 10,000 psi)�
The pump has a 2�2 Kw (3 HP) air-driven motor at
3,000 RPM (optimum performance based on 5�5 bar
(80 psi) air pressure and 1�4 M
pump)�
•
Minimum 9�5 L (2�5 Gal) reservoir�
•
Two-speed operation for rapid operation�
NOTE: The air supply must be minimum 1.4 M
(49 CFM) and 5.5 bar (80 psi), with
7 bar (100 psi) the maximum. Use of an air
filter/lubricator is recommended.
5.5 bar (80 psi) air supply is required to start
the pump under full load.
© SPX FLOW, Inc.
DESCRIPTION
RWP55 Series Air/Hydraulic Pumps
/min� (49 CFM) at the
3
/min.
3
Figure 1. Air Pump
(RWP55-4-BS Shown)
3
Form No. 1000680
Rev. 5
Nov. 24, 2022
Advertisement
Table of Contents
Need help?
Do you have a question about the Bolting System RWP55-BS and is the answer not in the manual?