Table of Contents
Advertisement
User manual
P/N 3-9008-515
3. Unscrew the end cap and remove it from the housing.
4. Unplug one or two ¾-14 NPT ports (as required) and install the conduit (provided by
5. Install the electronics according to
6. Screw the end cap to the housing. Hand-tighten, only if required.
7. Install the security latch.
Important
The security latch prevents the removal of the LME cover in a flameproof
environment.
the customer) to the enclosure and tighten.
Daniel if the preamplifier acquired is other than a dual channel preamplifier.
WARNING
SHOCK AND EXPLOSION HAZARD
Verify that the LME and/or RME is grounded.
Failure to comply may cause death, serious injury and/or equipment damage.
Wiring and cable
connections. Consult with
USER MANUAL
Installation procedure
March 2019
69
www.Daniel.com
Advertisement
Table of Contents
