Ducati Superbike 1198 2010 Owner's Manual page 39

Clock setting function
E
This function is used to set the clock time.
To set the clock, select the "TIME Set" page from the menu.
From this page, if you press switch (1, fig. 10) in position B
"▼" for 3 seconds, you enter clock setting mode.
On entering this function, the message "AM" flashes on
the display: if you press switch (1, fig. 10) in position B "▼",
the message "PM" flashes on the display; pressing switch
(1, fig. 8) in position B "▼" again returns you to the previous
step (if the time is 00:00, when you switch from AM to PM
the time 12:00 will appear);
if you press the switch (1, fig. 10) in position A "▲", you pass
to the hours setting mode and the hours digits will start
flashingd. Each time you press the switch in position B "▼",
the count advances cyclically in steps of 1 hour; if you hold
the switch down in position B "▼", the count advances
cyclically in steps of 1 hour every second (when the switch
is held down continuously, the hours do not flash);
if you press switch (1, fig. 10) in position A "▲", you enter
the minutes setting mode and the minute digits will start
flashing. Each time you press the switch in position B "▼",
the count advances cyclically in steps of 1 minute; if you
hold the switch down in position B "▼", the count advances
cyclically in steps of 1 minute every second. If the switch is
held pressed in position B "▼" for more than 5 seconds, the
minutes advance by 1 every 100 ms (when the switch is held
in position B "▼" continuously, the seconds do not flash);
if you press the switch in position A "▲", the system exits
setting mode and displays the newly set time.
38
B = ON for 3 secs.
Flashing
B
Flashing
B
Flashing
B
Flashing
B
B
A
B
A
A
A
A
Flashing
A
Flashing
fig. 28