Table of Contents
Advertisement
LAP time display function
E
This function displays the recorded lap time.
To activate this function, go into the menu and set the "LAP"
function to "On" by pressing switch (1, fig. 10) in position B
"▼" for 3 seconds.
To START and STOP the timer press the high beam flasher
switch (12, fig. 5) on the left-hand handlebar switch.
When the LAP function is active, each time you press the
flasher switch, the display will show the lap time for
10 seconds, before reverting to normal mode.
You can save a maximum of 30 laps in the memory.
If the memory is full, each time you press the flasher switch,
no more lap times can be saved and the display will show
the flashing message "FULL" for 3 seconds until the
memory is reset.
fig. 21
27
Advertisement
Table of Contents
