Table of Contents
Advertisement
Instrument panel
(fig. 4)
1) LCD (see page 13).
2) TACHOMETER (rpm).
Indicates engine revs per minute.
3) NEUTRAL (N) INDICATOR (GREEN).
Illuminates when the gearbox is in neutral.
4) FUEL WARNING LIGHT
Illuminates when there are approximately 3 litres of fuel left
in the tank.
5) TURN SIGNAL INDICATOR LIGHT
Illuminates and flashes when the turn signal is in operation.
6) ENGINE OIL PRESSURE WARNING LIGHT
Illuminates when engine oil pressure is too low. This light
should illuminate when the ignition is switched to ON and
should go out a few seconds after the engine starts.
It may come on briefly if the engine is very hot, but
should go out again as engine speed increases.
Important
If this light (6) stays on, stop the engine to avoid
serious damage.
7) HIGH BEAM WARNING LIGHT
Illuminates when the high beam headlight is on.
(YELLOW).
(GREEN).
(RED).
(BLUE).
2
5
9
8
6
8) "EOBD ENGINE DIAGNOSTICS LIGHT"
The engine ECU illuminates this light to indicate errors and,
in certain cases, consequent engine lockup.
9) "MOTORCYCLE DIAGNOSTICS" LIGHT.
Illuminates when the motorcycle diagnostics detects a
problem.
10) OVER REV WARNING LIGHTS.
Indicator light 10A: illuminates steadily at 800 rpm before
intervention of the rev limiter.
Indicator lights 10A + 10B: illuminate steadily 400 rpm before
intervention of the rev limiter.
Indicator lights 10A + 10B + 10C: start flashing when the rev
limiter is reached.
10A
10B
10C
3
4
7
5
(AMBER).
E
1
fig. 4
11
Advertisement
Table of Contents
