Every 300 Hours; Checking Tire; Every 400 Hours; Changing Transmission Fluid - Hisun VECTOR 500 Owner's Manual

Table of Contents

Advertisement

① Hose
② Hose joint

EVERY 300 HOURS

■ Checking Tire

1.
Check to see if tires are not damaged.
2.
If the tires are cracked, bulged, or cut, or they
are worn out, replace or repair them at once.
◆ Tire Tread Depth
Always replace the tires when the tread depth is
worn to minimum allowable.
① 3mm(0.12in)

EVERY 400 HOURS

■ Changing Transmission Fluid

CAUTION
To avoid personal injury:
Park the vehicle on a flat surface, raise the
cargo bed, mount the safety support.
Periodic Service
1.
2.
3.
4.
① Drain plug
IMPORTANT:

■ Changing Front and Rear Axle Case Oil

1.
2.
3. Fill with the new oil up to the upper
10-15
Allow engine to cool down sufficiently,
oil can be hot and can burn.
Park the vehicle on a flat surface, raise the
cargo bed, mount the safety support.
To drain the used oil, remove the drain
plug at the bottom of the transmission case
and drain the oil completely into the oil
pan.
After draining, reinstall the drain plug.
After running the engine for a few minutes,
stop the engine and check the oil level
again; add oil to prescribed level.
Do not operate the vehicle immediately
after changing the transmission fluid.
Run the engine at medium speed for a few
minutes
to
prevent
transmission.
Park the vehicle on a firm, flat and level
surface.
To drain the used oil, remove the drain the
oil completely into the oil pan.
notch on the dipstick.
damage
to
the

Advertisement

Table of Contents
loading

Table of Contents