Checking Coolant Level; Cleaning Radiator Screen - Hisun VECTOR 500 Owner's Manual

■ Checking Coolant Level

CAUTION
TO avoid personal injury

Do not remove radiator cap while coolant
is hot, when cool, slowly rotate to the first
stop and allow sufficient time for excess
pressure to escape removing the cap
completely.
1. Park the vehicle on a flat surface, access the
panel under the hood, set the parking brake, and
shut off the engine.
2. Check to see that the coolant level is between
the "FULL" and" LOW" marks of recovery tank.
3. When the coolant level drops due to
evaporation, add water only up to the full level. In
case of leakage add anti-freeze and water in the
specified mixing ratio up to the full level.(see flush
cooling system and changing coolant in EVERY 2
YEARS in PERIODIC SERVICE section)
① Recovery tank
② FULL
③ LOW
Periodic Service
IMPORTANT




■ Cleaning radiator screen

TO avoid personal injury:

1.
2.
3.
① Radiator screen
IMPORTANT

10-4
If the radiator cap has to be removed,
follow the cautions above and securely
retighten the cap.
Use clean fresh water and anti-freeze to fill
the recovery tank.
If water should leak, consult your local
HSUN Dealer.
CAUTION
Be sure to stop the engine before
removing the screen
Park the vehicle on a flat surface,
Remove the radiator cover,
Detach the screen and remove all foreign
materials,
Radiator screen must be cleaned from
debris to prevent engine from overheating