Coolant Level; Engine Oil - Hisun STRIKE 1000 Owner's Manual

Checking engine oil level
1. Park the vehicle on a flat surface, raise the
cargo bed, apply the parking brake, and shut
off engine.
2. To check the oil level, draw out the dipstick,
wipe it clean, replace it, and draw it out again,
check to see if the level is too low, add new oil
to the prescribed level on the dipstick.
① ~② Oil level is acceptable within this range
③Oil indicator
① Low Oil Level
④ Dipstick
■ Checking Coolant Level
CAUTION
TO avoid personal injury

Do not remove radiator cap while coolant
is hot. When cool, slowly rotate to the first
stop and allow sufficient time for excess
pressure to escape before removing the
cap completely.
1. Park the vehicle on a flat surface, access the
panel under the hood, set the parking brake,
and shut off the engine.
2. Check to see that the coolant level is between
the "FULL" and" LOW" marks of recovery tank.
3. When the coolant level drops due to
evaporation, add coolant only up to the full
level. In case of leakage add anti-freeze and
water in the specified mixing ratio up to the full
level.(see flush cooling system and changing
coolant in EVERY 2 YEARS in PERIODIC
SERVICE section)
PERIODIC SERVICE 10-6
1. Recovery tank
2. FULL
3. LOW
IMPORTANT



■ Cleaning radiator screen
TO avoid personal injury:

1.
2.
3.
① Radiator screen
If the radiator cap has to be removed, follow
the cautions above and securely retighten the
cap.
Use clean fresh water and anti-freeze to fill the
recovery tank.
If water should leak, consult your local HISUN
Dealer.
CAUTION
Be sure to stop the engine before removing
the screen
Park the vehicle on a flat surface,
Remove the radiator cover,
Detach the screen and remove all foreign
materials,
② DETACH