Inspection/Setup - MQ Power WHISPERWATT DCA600SSV4F3 Operation Manual

ENGINE OIL CHECK
1. To check the engine oil level, place the generator on
secure, level ground with the engine stopped.
2. Remove the dipstick from its holder (Figure 33) and
wipe it clean.
DIPSTICK
Figure 33. Engine Oil Dipstick
3. Reinsert the dipstick, then remove the dipstick from
its holder. Check the oil level shown on the dipstick
(Figure 34).
Figure 34. Engine Oil Dipstick
4. Verify that the engine oil level is maintained between
the H and L markings on the dipstick as referenced in
Figure 34A .
5. If the engine oil level is low (Figure 34C), remove the
oil filler cap (Figure 35) and fill to a safe operating level
(max) as indicated by the dipstick (Figure 34A).
NOTICE
When adding engine oil, DO NOT overfill (Figure 34B).
PAGE 36 — DCA600SSV4F3 60 HZ GENERATOR • OPERATION MANUAL — REV. #2 (11/15/22)
6. Fill with recommended type oil as listed in Table 10.
6 0
0
7. When checking the engine oil, be sure to check if the oil
8. Allow enough time for any added oil to make its way

INSPECTION/SETUP

Maximum oil capacity is 12.7 gallons (48 liters).
OIL FILLER
PORT
Figure 35. Engine Oil Filler Port
is clean. If the oil is not clean, drain the oil as referenced
in the maintenance section of this manual.
to the oil pan before rechecking.
Table 10. Recommended Motor Oil
6 0
0