Image Selection; Digital I/O; System Log / Event Log; Saving Snapshots - Bosch NDC-225-P Installation And Operation Manual

88 en | Operation via the browser
7.1.2

Image selection

View the image on a full screen.
1.
7.1.3

Digital I/O

Depending on the configuration of the unit, the alarm input and
the relay output are displayed next to the camera image. The
alarm symbol is for information and indicates the input status
of the alarm input: Active 1 = Symbol lights, Active 0 = Symbol
not lit.
The relay on the camera allows operation of a device (for
example, a light or a door opener).
1.
7.1.4

System Log / Event Log

The System Log field contains information about the operating
status of the camera and the connection. These messages can
be saved automatically in a file. Events such as the triggering or
end of alarms are shown in the Event Log field. These messages
can be saved automatically in a file.
To delete the entries from the fields, click the icon in the top
right-hand corner of the relevant field.
7.1.5

Saving snapshots

Individual images from the video sequence that is currently
being shown on the Livepage can be saved in JPEG format on
the computer's hard drive.
1.
The storage location depends on the configuration of the
camera.
7.1.6

Recording video sequences

Sections of the video sequence that is currently being shown on
the Livepage can be saved on the computer's hard drive. The
AR18-09-B003 | v1.1 | 2010.05
Click the Stream 1, Stream 2 or M-JPEG tab below the
video image to switch between the different displays for
the camera image.
To operate, click the relay symbol. The symbol is red when
the relay is activated.
Click the camera icon
Installation and Operation Manual
IP Camera 200 Series
to save single images.
Bosch Security Systems