Power Connector - Bosch Dinion2X Installation And Operation Manual

28 en | Installation
5.2

Power connector

Figure 5.2 Power connection
Connect power from a 24 VAC or 12 VDC class 2 power supply
as follows:
– Use AWG16 to 22 stranded wire or AWG16 to 26 solid
wire; cut back 5 mm (0.2 in) of insulation.
– Loosen the screws of the supplied 2-pole connector and
insert the wires.
– Tighten the screws and insert the 2-pole connector into
the power socket of the camera.
Note:
For a DC supply the polarity is important. Incorrect polarity
does not damage the camera but it will not switch on.
AR18-10-B006 | v1.1 | 2010.06
This manual downloaded from http://www.manualowl.com
ALA RM
E
1
4
T
2
5
H
3
6
P
VID EO
o
E
5 mm
0.2 in
Installation and Operation Manual
Dinion2X IP Camera
–
+
12 VD C
24 VA C
DA TA
1
4
2
5
3
6
Bosch Security Systems